User`s manual

34
For standalone units working with Wide SCSI drives, the settings should be:
40-16-ON.
For units installed with the V1Xserver, the settings should be: 10-16-ON.
For the MPEG2 and DCT units with a loop SCSI cable (2 SCSI connectors in the
back), the Termination should be OFF.
(12) V1 Type Select the TOGGLE button to switch between Player Only or Rec/Player. This
option is used when more than one V1 unit are connected to the same drive or
RAID. You can only have one unit set in Rec/Player and all the rest should be
Player. The Rec/Player is the only unit allowed to record on the network.
Important Note: When the unit is in Player Only mode, all operations that write
to the active drive are denied, including record, initialize, format, etc.
(13) Video Type Select the TOGGLE button to switch between NTSC and PAL. If you want the
new setting to be the default startup setting, a Save command should be executed
after changing this parameter. The unit will switch only after the drive is
initialized.
>>UncompHDTV ONLY This function allows you to select between the different
HD formats of your source below by pressing the TOGGLE button:
1080 50i
Selects 1080 line interlaced 24 frame /sec standard
1080 30p
Selects 1080 line progressive 30 frame /sec standard
1080 25p
Selects 1080 line progressive 25 frame /sec standard
1080 60i
Selects 1080 line interlaced 30 frame /sec standard
720 60p
Selects 720 line progressive 60 frame /sec standard
1080 24p
Selects 1080 line progressive 24 frame / sec standard
(17) SCSI ID Select the TOGGLE button to switch between 0, 1, 2, ..14 and 15. The selection
represents the SCSI ID number of the V1 after restart. Do not use a SCSI ID
number for the V1 that conflicts with any installed drive. A Save command
should be executed after changing this parameter. The default SCSI ID is 7.
(18) Clks/Frame Select the TOGGLE button to switch between 01, 02, 04, 10. The selection
represents the number of clicks on the incoming Biphase signal per video frame
(01= 1 click per frame). In PAL 25 frames/sec, 01=25Hz, 02=50Hz, 04=100Hz,
10=250Hz. If you want the new setting to be the default startup setting, a Save
command should be executed after changing this parameter.
(19) Emulation The "++" or "--" will toggle between V1 (default), BVW-75 and DVW-500. If you
want the new setting to be the default startup setting, a Save command should be
executed after changing this parameter.
(20) # Audio Ch Select the TOGGLE button to switch between 0. 2. 4. and 8 which designate the
number of audio channels to be recorded. Changing this menu will take effect only
after you initialize the drive.
(21) Jog On Select the TOGGLE button to switch between “1&2”, “3&4”, “5&6” and “7&8”.
When the V1 is playing at any speed below 100%, the audio will output from only
two channels. Use this option to select which tracks the audio will be on when the
V1 is playing at any speed below 100%.
(22) Loop Mode Select the TOGGLE button to switch between OFF and ON. When this option is
set ON, the V1 will record (play) in a loop specified by the clip (segment) selected