User`s manual

32
(03) Set Video This menu option will allow you to set the video parameters. The ++ key will
switch between:
Delay
This parameter sets the delay until the video output goes black
(screen saver). Hold the OPTION and the TOGGLE to move
the delay down by 10 seconds, TOGGLE will move it up by 10
seconds. "000" will disable this feature, "010" will cause the
unit to output black video when the unit is idle for 10 seconds.
Pattern
Video Pattern. Use the TOGGLE button to switch between ON
and OFF.
Out
Use the TOGGLE button to select the output as RGB, YUV or S
Video
CH PH
Chroma Phase. Use the TOGGLE button to increase or decrease
the chroma phase from 0 to 360. You can also enter a number
from the keypad followed by the ENTER key
HTRIG
on/off
HTRIG adjustment. Use the TOGGLE key to set the HTRIG
adjustment ON or OFF.
HTRIG
value
Hold the OPTION and TOGGLE key to move the picture to
the left, TOGGLE will move it to the right. You can also enter
a number from the keyboard followed by the ENTER key.
Black
Sets the black level to 0V for the Japanese standards and 0.75V
for the American standards. Used in NTSC only.
PAL Switch
0 or 1. Use the TOGGLE button to set the value according to the
PAL standard used in your area (A or B)
Luma Brit
Luma Brightness. Use the TOGGLE button to set. 00 is the
default value of the analog input.
Luma Cont
Luma Contrast. Use the TOGGLE button to set. 00 is the default
value of the analog input.
Chroma Sat
Chroma Saturation. Use the TOGGLE button to set. 00 is the
default value of the analog input.
Chroma
Hue
Chroma Hue. Use the TOGGLE button to set. 00 is the default
value of the analog input.
Comp Brit
Composite Brightness. Use the TOGGLE button to set. 00 is the
default value of the analog input; Component YUV/RGB
Comp Cont
Composite Contrast. Use the TOGGLE button to set. 00 is the
default value of the analog input; Component YUV/RGB
Comp Sat
Composite Saturation. Use the TOGGLE button to set. 00 is the
default value of the analog input; Component YUV/RGB
VTrig
Use the "++" or "--" to set the VTRIG Adjustment. 00 is the
default value. The "--" will move up the picture, "++" will move
it down. You can also enter a number from the keyboard
followed by the ENTER key.
This option is not saved on the drive, it is saved on the V1 flash EPROM only if
you execute a Save from optional menu (04).
(04) Save This menu option will save all the Flash EPROM settings of the V1. To write the
changes on the Flash EPROM (see Note below), press the ++ key.
A message will appear on the LCD screen: “Are you sure?” :
♦ If you want to save, hold the OPTION key and press the “--“ key again,
The V1 will write the changes on the Flash EPROM.
♦ If you change your mind and don't want to save, press ESC.
NOTE: THIS FUNCTION SHOULD NOT BE ABUSED BECAUSE THE
FLASH EPROM CAN ONLY BE WRITTEN 2000 TIMES. IF YOU SAVE
YOUR SETTINGS ON THE FLASH EPROM MORE THAN 2000 TIMES
YOU MIGHT DAMAGE IT AND NEED TO REPLACE IT BY SENDING
THE UNIT BACK TO DOREMI LABS.