User`s manual

31
Important notes
:
♦ Hitting ENTER after each of these sub-menus will save your choice
and launch the copy operation, so do not press ENTER until you
have entered all the correct values in the sub-menus.
♦ The destination drive must be previously initialized on a V1. The
copy will be aborted if the destination drive is not a V1 drive.
♦During the copy process, the LCD will display a counter showing
how much is left to be copied (in Gbytes, Mbytes), when finished, it
will display "Completed".
♦ The copy process will only copy valid recordings from the source
drive. If the source drive has invalid recordings or bad sectors in the
recording to be copied, the LCD will display "Copy aborted" and
will abort the copy process. In this case check your recording on the
source drive, and record it again if it is damaged or contains bad
sectors.
♦ Caution!
: Your destination drive will be fully erased by the
copy.
(02) Edit Preset This feature will allow you to select which audio track(s) to edit/overdub while
the other non selected track(s) are monitored at the same time. For the V1-U the
overdub feature is only supported on the Seagate Cheetah SCSI hard drives 15k
RPM. For the V1-MP2 & DCT you can use 10k RPM drives. For the V1-UHD it
requires at least 4 15000 RPM drives or the dual-SCSI external drive setup. In
addition the with the V1-UHD you can do “assemble” or “audio” only.
This feature is used only when you are using the front panel to do the overdub. If
you are using an edit controller the edit controller will set these options
automatically. The settings the edit controller has selected will be reflected here.
The ++ key will switch between the following selections:
A1 To insert/overdub on audio track 1, select On by pushing the
TOGGLE key.
A2 To insert/overdub on audio track 2, select On by pushing the
TOGGLE key.
A3 to A8
If your V1 includes additional Audio in/out tracks (up to 8) they
will be listed consecutively here
TC To insert/overdub time code on the guide track, select On by
pushing TOGGLE key. Note that you can use the "Time Code
Offset" function and keep this option Off.
Video To insert/overdub video, select On by pushing the TOGGLE key.
Assemble If this submenu is set to On by pressing the TOGGLE key, all
previous submenus 1., 2.,3. & 4 will default to the On position and
the drive is set for normal recording (video, audio and time code).
You can select Off by pressing the "--" key. The reason for the
On/Off toggle for video is to allow the V1 to record while in
PLAY mode (Usually required by Editors using RS422 control), in
this case, the sub-menu Assemble must be On.
Insert Select On or Off by pressing the TOGGLE key. Enables or
disables the ability to insert video or audio using the front panel.
The overdub procedure is explained further in Section 5.1.2