User`s manual

30
4.2 Option Menu
Hold the OPTION and the MENU key to call up the “Option menus”. The up arrow key ! (or down
arrow key ") will allow the user to get to the next (or previous) menu selection. If there are submenu
selections for the Menu items use the ++ or – buttons to scroll through the selections. The TOGGLE
button generally sets the parameters for the selected menu. Press TOGGLE to increase the parameter
and hold OPTION and TOGGLE to decrease the parameter. Once menus are set-up, pressing the ESC
key will save the settings and quit the menu mode.
OPTION Menus (05) and (06) are saved on the active drive. So if this drive is mounted on another
V1 unit, all these settings will be recovered.
V1 Info. If you are in Option Menu (00) and hit the down arrow key,
the V1 will display
information about the unit. The TOGGLE button
will switch between: Version
Number, IP address, Ethernet Port Address, the amount of RAM used on that unit
and the unit’s serial number.
(00) Auto Play >>DCT & MPEG2 ONLY If you enter a segment number that is already defined
(See Section 5.2.5 "Segment Definition & Playback"). The V1 will play that
segment every time it mounts that drive. This function can also be used to
automatically locate to a start point every time the disk is mounted. All you need to
do is set the IN and OUT time at the same location for the auto-play segment.
(01) Disk Copy >>DCT & MPEG2 & UncompSD (single file system) ONLY This feature will
allow you to make duplicates of one recording from one disk to another without
the need to re-record the video thus allowing video, audio time code, segments
definition and menu set-up to be transferred digitally from one drive to the other.
First make sure your source disk is the active drive
(when you hit play, only the
source disk should be playing) then power up (insert cartridge in) your destination
drive(s). Engage the Disk Copy menu, the ++ key will switch between each of the
following sub-menus:
Source is
Type the SCSI ID number of the source drive (Valid range from
0 to 15), then use "++" to go to the next sub-menu.
# Targets
Type the number of drives that will act as your destination
drives (Valid range from 1 to 4), if you enter a value higher than
the maximum allowed, the V1 will default to its maximum, then
use "++" to go to the next sub-menu.
Target #1
Type the SCSI ID number of the destination drive number 1
(See Caution below). If you specify more than one target, you
will be prompted for Target #2, etc..., then use "++" to go to the
next sub-menu.
Segment #
If you wish to copy only a segment (already defined on the
source drive), enter the segment number, from 1 to 2047, and if
previous menus 1,2,3 have the values you need, press ENTER to
start the copy process. If you need to perform a full copy, then
use "++" to go to the next sub-menu.
Full Disk
If you wish to copy the full disk, and if previous menus 1,2,3
have now the values you need, press ENTER to start the copy
process. If you do not want to perform the copy operation at this
time hit ESC , use "++" or "--" to go to other sub-menus.