User`s manual

2.3 Transport Controls

The V1 standard transport controls are:

REC Record control button. This key is used in several ways described later

in this menu.

STOP Stop control button. The STOP key will cause the V1 to stop any

transport control (Play, record, rewind, fast forward).

PLAY Play control button. If the active drive has recorded material, pressing

the PLAY key will start playback from the current location at normal

speed and the green LED will go ON.

REW Rewind control button with a speed of 40 times normal. When the

rewind is close to the beginning of the recording, the speed is slowed

down to normal until it reaches the start. Pressing this key again will

increase the speed. There are three levels REW+REW+REW.

FF Fast forward control button with a speed of 40 times normal. When the

fast forward is close to the end of the recording, the speed is slowed

down to normal until it reaches the end. Pressing this key again will

increase the speed. There are three levels FF+FF+FF.

2.4 LCD Time Code Display

The first line of the Time Code display shows the time location of the video material using the following

format: “HH:MM:SS:FF F1/F2” where "HH" represent the hours from 00 to 23, "MM" represent the

minutes from 00 to 59, "SS" represents the seconds from 00 to 59, "FF" represents the frames from 00 to

24 in PAL and 00 to 29 in NTSC, "F1/F2" represent the field: "F1" for odd fields and "F2" for even

fields. This display will show either Absolute Time or Time Code depending upon what the user has

selected in the "Time Mode" (01) Menu. The display also shows Drop/NonDrop information; “.” Means

NonDrop and “;”means DROP frame. Field one shows “.” Field two shows “:” or “;”

The second line displays the following:

♦ At the V1 start-up, the bottom left displays the version of the front panel (RCV2) software installed

on the flash EPROM (example, V .71 when version .71 is installed), then No Disk and Scanning

messages will alternate on the left side and Stop is displayed on the right side until a valid drive is

recognized on the SCSI bus of the V1, in such case No Disk will disappear and only Stop will be

displayed indicating that the V1 is now ready to access the drive. If No Disk/Scanning is still

displayed even though a disk was installed, the V1 did not recognize the disk. Check for SCSI ID

conflict or check the MD settings in Option Menu 30.