Instruction manual

63
G. Forward-Facing with Vehicle Belt
64
continued on next page.
G-5 Install Forward-Facing
With Vehicle Belts
Secure UAS Belts
You MUST attach the UAS
belt hooks to the side of the
shell as shown when using
the vehicle seat belts.
1.
Note: Review the section D-4 to determine what kind of
vehicle belts you have. Review your vehicle’s owner manual for
vehicle seat belt use.
2
1
Rotate Recline Stand
Out and Push Up to Lock
2.
Installation Tip:
Thread Vehicle Belt
Thread the vehicle lap or
lap/shoulder belt through the
forward-facing belt path and
out the other side.
With an ALR vehicle belt, pull
the vehicle belt all the way
out before threading the
child restraint.
With a switchable retractor,
pull the shoulder belt all the
way out to switch the
retractor into the ALR mode
before tightening.
Buckle vehicle belt.
4.
Loosely attach the
tether hook before
threading the vehicle
belt. Consult vehicle’s
owner manual for
specific location.
Place Child Restraint in
Vehicle Forward-
Facing in the Back Seat
Place child restraint flush
against the vehicle seat
back forward-facing.
Do not fold the recline
stand when forward-
facing.
Note: Do not use the level
to ground line on the side
of the child restraint in the
forward-facing position.
3.
Do not use the UAS along with the vehicle lap or
lap/shoulder belt. Secure UAS belts when using
the vehicle belts.
Check the vehicle belt before each use. Use only if
the belt is tightened properly and securely.
Do not fold the recline stand when forward-
facing.
Failure to follow these warnings can result in
serious injury or death.
4358-5405 Can Scenera 12/8/10 2:50 PM Page 65