Instruction manual

Pull Vehicle Belt Across
Infant Restraint
Thread vehicle seat belt under
pad in front of buckle/crotch
strap to the opposite side.
Buckle vehicle belt.
Do not place vehicle belt
over infant’s legs.
NOTE: The buckle/crotch strap MUST be in the 1st or 2nd
buckle/crotch strap slots when rear-facing. Any slot can be used
for forward-facing.
4
3
6
0
-06
8
1
Place Infant Restraint in
Vehicle Rear-Facing in
the Back Seat
With infant restraint in the
reclined position, make sure
level to ground lines on the
side of the infant restraint are
level with ground. Adjust
infant restraint if needed.
NOTE: If you cannot get the
level to ground line level to
the ground (horizontal), you
may use a tightly rolled
towel(s) or a foam noodle(s)
under the front of the infant
restraint where the vehicle’s
seat back meets the vehicle’s
bench seat.
4.
4360-0681
L
i
ne
to
be
L
e
v
e
l
To
G
r
ound
R
e
ar
-
F
ac
i
ng
O
n
l
y
Thread Vehicle Belt
Thread the vehicle
lap/shoulder belt through
the rear-facing belt path.
5.
Locate Locking Clip
Location
Grasp the vehicle
lap/shoulder belts
together tightly as close to
the vehicle latch plate as
possible. While holding the
belts tightly, unbuckle.
NOTE: If the latch plate ends up just at the belt path
opening so you cannot grasp the vehicle belt at the latch
plate, grasp the vehicle belts on the opposite side of the
infant restraint, as close to the latch plate as possible.
Install the locking clip on the latch plate end, as close as
possible.
Tighten Vehicle Belt
Push down firmly on the
infant restraint while pulling
up on shoulder part of belt
until all slack is removed
and lap belt is tight.
7.
8.
2
1
6.
Attach Locking Clip
Thread both portions of the
vehicle belt onto the
locking clip, as close to the
latch plate as possible.
9.
D. Using the Locking Clip
39
40
continued on next page.
4
3
6
0
-06
8
1
4358-5405 Can Scenera 12/8/10 2:50 PM Page 41