Instruction manual

Infant Insert and Head/Hip Roll
(on select models)
NOTE: Depending on your model, follow the information
concerning the infant insert that matches your model.
The infant insert is designed to support the infant’s head and
neck. Make sure that the insert does not cover the infant’s face
in any way. Remove the insert when the infant’s head has
reached the top inside part of the infant insert.
C. Basic Use
Remove the head/hip
roll when NOT using
the lowest harness
slot position. Death
or serious injury can
occur.
To remove this infant insert,
undo the fastening strips at
the back of the head roll. To
replace, fit infant insert
around harness straps and
refasten strips.
To remove this head/hip roll,
undo the fastening strips at
the back of the head roll,
between the harness slots
and buckle. To replace, fit
head roll around harness
straps and refasten strips.
Body Pillow
(on select models)
To remove this body pillow,
slide out from behind the
the harness straps.
NOTE: Depending on your model, follow the information
concerning the body pillow that matches your model.
Body Pillow
(on select models)
To remove this body
pillow, unhook the
harness straps from
splitter plate and pull
harness straps out of the
upper harness slots.
Unthread harness straps
from the chest clips and
buckle tongues. Remove
body pillow. Rethread
harness straps and re-
hook the harness strap
loops to the splitter plate
(review sections C-7 and
C-9).
23
24
4358-5405 Can Scenera 12/8/10 2:50 PM Page 25