Owner`s manual

46
47
1.If your child restraint is not held securely
by the belt:
Press down firmly on the child restraint and remove all the
slack in the belt.Make sure the belt buckle is not up against
the child restraint where the belt cannot be tightened.
Review Locking Clip section and Top Anchorage Strap
Section. If you cannot secure the child restraint tightly,
move it to another seating location.
2.If the child restraint buckle or harness
adjustment lever sticks or you cannot get the straps
tight enough around child:
DO NOT LUBRICATE.Check around buckle and harness
release lever for dropped food,sticky spilled drinks, dirt,
leaves,etc.
Clean with warm water and/or remove object
with tweezers.
If you cannot get the harness to adjust and
remain tight with the buckle securely locked,do not use the
child restraint.
3.If your harness twists or ropes:
Straighten the harness each time you put your child in the
seat to help prevent twisting. Lock the buckle and tighten
harness and it will be ready for next use.
4.If your infant sits too upright in
the rear-facing position:
If your vehicle seat slopes so much that
your infant is sitting upright,you may
place a rolled towel under the front of
the child restraint so that the level line on
the side of shell is level (horizontal).
Check often to be sure padding is still in place and the
vehicle belt is tight.
WARNING
Using padding that tilts the child restraint
farther back than the level-to-ground line
can result in serious injury or death.
Trouble Shooting
!
WARNING
!
Failure to reattach the buckle and harness
correctly, can result in serious injury or
death.
From the back of the seat,
fasten harness to splitter
plate.
4
4358-3395F Touriva 7/2/07 8:31 AM Page 49