Owner`s manual

44
45
3
Thread the harness down
through slot on left side of
shell (1),across bottom of
seat (2) and up through
slot on right side (3).
Thread one buckle plate
onto harness from back to
front (4).Thread the
harness retainer (5).Do
the same to the other
harness end.Make sure
the harness is not twisted.
Push harness ends through
upper slots in shell (6).
1
2
3
4
5
6
1
Fit the buckle strap down
through the slot in the seat.
Make sure buckle faces out.
From the bottom of seat,
pull buckle’s metal clip
completely through pad
and shell.
Reinstall Harness
2
Pull up on buckle to make
sure buckle’s metal plate is
completely through the
pad and shell.
WARNING
!
Failure to place buckle’s metal plate
completely through pad and shell can result
in serious injury or death to the child.
continued on next page.
Unsnap the bottom of pad
from shell.
Clean with warm sudsy
water,rinse clean and air
dry. Do not use bleach or
other harsh cleaners.
Pull pad off the shell,
starting at the top.
Remove pad from sides of
shell.
6
7
Replace seat pad by
reversing order,starting
from bottom of child
restraint,snap pad on
shell;tuck in pad around
harness adjuster;attach
pad to sides of shell. Make
sure holes in foam pad
align with harness guide
holes before wrapping pad
over top of shell. Replace
the 6 harness guides.
8
4358-3395F Touriva 7/2/07 8:31 AM Page 47