User Manual

Installing the batteries in Baby’s Unit (transmitter):
R E Q U I R E D :
Phillips Scre w d r i v e r
4 "D" Size Alkaline Batteries
1. Remove screws from battery cover and remove cover.
2. Insert 4 "D" size alkaline batteries into the battery compartment by matching the (+) and (-) symbols. (Figure 1)
N O T E : The low battery indicator illuminates when the batteries need to be re p l a c e d .
3. Replace the battery cover and insert and tighten the scre w s .
Attaching Baby’s Unit to Crib:
R E Q U I R E D :
B a b y ’s Unit (transmitter)
Crib Clamp Assembly
1. Set the Baby’s unit to setting "A". If you experience static or noise interf e r ence, switch both
units to setting "B". Power On Indicator should be illuminated.
2. Place Baby’s Unit in desired location on crib slats with Baby Looney Tunes characters facing
i n w a r d. Screw shaft should be resting on the crib rail. (Figure 2) (Do not translate text in re d )
3. Holding Baby’s Unit in place, insert crib clamp assembly into shaft (Figure 3)
4. Tu r n knob clockwise to tighten until secure. (Figure 3)
Using the Crib Light
Your Baby Looney Tunes Baby’s Unit (transmitter) includes a crib light feature that is activated
by the sounds of your baby and can also be activated manually.
1. Slide voice activation sensitivity switch to the desired sensitivity setting. Set to high sensitivity
when you want the crib light activated by quieter sounds or low sensitivity when you want
the crib light activated by louder sounds.
N O T E : The crib light will automatically shut off after five minutes.
2. To activate the crib light manually, press the manual crib light button. (Figure 4)
3. To shut off the crib light manually, press the manual crib light button. (Figure 4)
Installing the batteries in Pare n t ’s Unit ( Receiver):
1. Remove screw from battery cover on Pare n t ’s Unit and remove cover.
2. Insert a 9-volt battery into the battery compartment by snapping the battery contacts
into the corresponding connectors on the battery clip in the unit. (Figure 5)
N O T E : The low battery indicator illuminates when the batteries need to be re p l a c e d .
3. Replace the battery cover and insert and tighten the scre w.
Adjusting the Channels
1. Place the Pare n t ’s Unit at least 10 feet from the Baby’s Unit.
2. Plug the round end of the adapter into the Pare n t ’s Unit, then plug the adapter into an electrical outlet.
3. Set the Pare n t ’s Unit to setting "A". If you experience static or noise interf e r ence, switch both units to setting "B".
N O T E : C o n f i rm the Pare n t ’s Unit and Baby’s Unit are set to the same setting (A and A or B and B).
4. Adjust the volume so you can hear your baby at all times.
N O T E : The Pare n t ’s Unit may be mounted to a wall by using a screw (not included) to attach the unit using the keyhole located on the back
on the unit.
( F i g u r e 4)
( F i g u r e 5)
( F i g u r e 2)
( F i g u r e 3)
( F i g u r e 2)
( F i g u r e 3)
( F i g u r e 1)