User's Manual

Baby’s Unit:
For best results, place the Baby’s Unit on a table near the crib or bed. It should be facing
the baby’s head as close to the crib as possible, but out of baby’s reach.
To Install Battery (One 9 volt battery not included)
Locate battery carrier on bottom of the Baby’s unit and using Phillips head screwdriver
remove the screw and take off the battery carrier as shown.
Snap 9 volt battery (not included) onto the battery pad and return to battery carrier as
shown.
Replace battery carrier and secure with Phillips screwdriver as shown taking care not to
over tighten.
(LD of baby’s unit showing battery carrier screw being removed w/Phillips screwdriver)
(LD of 9 volt battery correctly snapped onto battery and pad being returned to proper
position in carrier)
(LD of battery carrier replaced on the unit w/indication of screw being replaced
w/Phillips screwdriver
To Activate Baby’s Unit
STEP 1 To use household power, plug the round end of adapter cord into the jack on the
Baby’s unit, then plug the the adapter into an electrical outlet.
NOTE: Battery power is available when one 9 Volt battery (not included) is installed in
the Baby’s Unit, however it is not recommended to use the battery power for extended
periods when household power is available.
STEP 2 Locate the channel selector on the back of the Baby’s unit. Select one of the four
channel options, and note your selection on a separate piece of paper.
STEP 3 Turn power switch to “ON” position. The LED Light on the Baby’s unit should
be illuminated.
To Activate Parent’s Unit:
For best results, the Parent’s Unit should be placed at least 10 feet away
from the Baby’s unit. The Parent’s Unit can be mounted to the wall by using
a screw (not included) to hang the unit using the keyhole on the belt clip on
the back of the unit.