User's Manual

Problem Possible Cause Solution
Camera’s Power On LED Indicator Camera is not turned “ON” Slide the ON/OFF switch to the
does not light “ON” position
Power is turned OFF Make certain house fuses and circuit
breakers are ON
Check to be sure light switches that
control power to wall outlet are ON
AC Adapter not Check AC Adapter jack-to-socket and
properly connected plug-to-outlet connections
No sound or picture Channel switches are not on Check the channel switches on BOTH
the same setting (A, B, C) Camera and Receiver. They must
correspond
Change channel setting on BOTH
Camera and Receiver. Channels
must correspond
Turn both the Camera and Receiver OFF.
Wait a moment, then turn ON again
Sound, but no picture on Television Camera is too far from Move Camera and Receiver closer together.
the Receiver
Camera’s Audio Only Switch is
positioned to ”Video Off”
Camera or Receiver
near metal concentration
Change channel setting on BOTH
Camera and Receiver. Channels must
correspond
TV may not be turned on Turn on TV
Picture, but no sound Volume not turned up Adjust volume on television.
Adjust volume on Receiver
Change channel setting on BOTH
Camera and Receiver
Audio feedback Receiver is too close to Move Camera further from
the Camera Receiver
Volume is too high Adjust Receiver volume.
Adjust volume on television
Dark picture at night Audio Night Sensor Infrared LED’s Turn room lights OFF and check
not functioning properly if Infrared LED’s are glowing. If not,
contact the Consumer Relations
Department at Safety 1st
Troubleshooting
Signal interference from
cordless or cellular phones or
other monitors in the area
Test reception by moving Camera closer to
Receiver or to different areas in house.
Relocate Camera
Signal interference from
cordless or cellular phones
or other monitors in the area
Page 11
Position Camera’s Audio Only Switch to
”Video On”
48018 sights & sounds 11/7/00 12:14 PM Page 11