User's Manual

Installing Your Home Connection Monitor System

• To prevent entanglement, only mount the Baby’s Unit in a location where it

and its AC adapter cord are OUT OF REACH OF CHILDREN.

• DO NOT mount the Baby’s Unit directly above heating vents, other heat

producing sources or in direct sunlight.

• To prevent entanglement and overheating, NEVER use an extension cord.

WARNING

To Charge the Parent’s Units:

IMPORTANT: You will need to fully

charge each Parent’s Unit BEFORE

FIRST USE and when low battery

indicator is illuminated.

Unscrew the two screws at the bottom

of each Parent’s Unit. Insert the

Recharging Battery with 2 pin

connector wire facing down. Connect

the two pin connector inside each

Parent’s Unit. Replace the bottom and

secure screws (Figure 1).

Connect an AC adapter into each

Parent’s Unit and into a power outlet

(Figure 1). It takes approximately 8

hours to fully charge.

Recharging

Battery

Screws

NOTE:

The Parent’s Units may use either the AC adapter or the rechargeable batteries

provided.

• When using batteries, check batteries

regularly. Amber LED indicates the

batteries are low. DO NOT rely on

Parent’s Unit when batteries are low.

CAUTION

For AC Power Use: Locate each Parent’s Unit and its AC adapter. Connect the

AC adapter into the side of the Parent’s Unit. Connect the AC adapter into a power

outlet.

CAUTION: DO NOT use an adapter or batteries that did not come with this

product.

For Battery Use: Charge the Parent’s Units as noted above.

NOTE: If desired, slide the belt clip over your belt.

2 Pin

Connector

08038_inst_E_112103 12/10/03 2:01 PM Page 5