SPECIFICATIONS

Vehicle Systems Specifications

Lift and Tilt Mounting Group

(1) (Standard Mast or Full Free Triple Lift mast Only):

With chains adjusted for equal tension, run mast

to full lift. If mast does not kick (move) to one

side, no shims are needed. If mast does kick

(move) to one side, disconnect cylinder from the

bar on that side. Add shim, connect cylinder,

adjust chains and run mast to full lift to check for

kick. Repeat process if necessary. The total shim

pack must not be more than three shims maxi-

mum.

(2) Install bearing outer race to a depth of (F) 4.5 L

0.8 mm (.177 L .031 in).

(3) Tilt cylinder installation shown for M40D thru

MC60d models.

(4) Bearing split to be located at angle (d) 45 L15¡

(5) Install bearing outer race to a depth of (G)

............................4.5 L 0.8 mm (.177 L .031 in).

(6) (Full Free Lift Mast Only):

Tighten nuts until U-bolts is firm against cylinder,

do not apply standard torque.

(7) (Full Free Lift Mast Only):

With chains adjusted for equal tension run mast

to full lift. If mast does not kick (move) to one

side, no shims are needed. If mast does kick

(move) to one side, hold lift cylinder tube on that

side and loosen bearing 1/4 turn and check mast

again. Loosen bearing until kicking (movement)

stops or gap (H) reaches 3.0 mm (.12 in) (approx-

imately 1.5 turns)), whichever is less. Insert shims

(8) under bearing (it may be necessary to loosen

bearing an additional amount of turns to install

shims). Tighten bearing again.

NOTE: Tighten the cylinder clamp bolts to a maxi-

mum torque of 35 NIm ( 26 lb ft) to prevent cylinder

rotation.

VIEW A-A

VIEW C-C

Bearing

Split

DETAIL E

VIEW B-B

IDCS176S

IDCS177S