SPECIFICATIONS

Vehicle Systems Testing And Adjusting
Drift Test For The Tilt System
1. Put a rated capacity load on the forks on the lift
truck. Operate the lift truck through a complete lift
and tilt cycle until the oil is at normal temperature
for operation, 45 to 55°C.
2. Put the mast in a vertical position. Raise a rated
capacity load to a height of 2.5 meters (8.2 ft). In
the case of trucks with less than 2.5 meters (8.2 ft)
height extension, raise the load to the truckÕs max-
imum height.
Tilt Drift Check.
3. The tilt drift is measured as the charge in the tilt
cylinder stroke. Measure any drift of the mast for
ten minute period.
Drift for shall not exceed 35.5 mm (1.40 in).
Steering System
Steer Wheel Bearing Adjustment
Bearing Adjustment
(1) Nut. (2) Lock
1. Tighten nut (1) slowly to 135 NIm (100 lbIft) while
the wheels is rotated in both directions put the
bearings into position.
2. Loosen nut (1) completely. Tighten nut (1) again to
50 L 5 NIm (37 L 4 lbIft) .
3. Bend lock (2) over nut (1) to hold the nut in posi-
tion.
47
1
2
IDCS192S
IDCS009P