SPECIFICATIONS

Vehicle Systems Testing And Adjusting

* Permissible tolerance L 0.08mm (.003in)

2. Find narrowest point by ruler on the inner mast in

the area where the bearings make contact.

3. Install enough shims (4) that have been divided

into two equal groups behind bearings (3). At

installation, there is to be contact [zero clearance

(A)] between the bearings and the narrowest point

of inner mast.

4. Do step 2 through 3 for other sets of bearings.

5. Tighten screw (5) that holds the top bearings to the

carriage to a torque of 34 L 7 NIm (25 L 5 lbI ft)

6. Shim stop bolt (11) as required to obtain a 6 to 9

mm (.24 to .35 in) lap with top carriage stop on the

inner upright.

Chain Adjustments

Chain Adjustment Check

Lift the carriage and mast high enough to put their

full weight on the carriage and mast chains. Check

the chains, and make sure the tension is the same.

Mast And Carriage Bearings

Part No. Bearing Size Bearing O.D.

D581814 Under Size 108.6 mm (4.276 in)

D581815 Standard 109.6 mm (4.135 in)

D581816 Over Size 110.7 mm (4.358 in)

IDCD014P

IDCD009P

IDCD006P

IDCD015P

IDCD016P