Specifications

Power Train Testing and Adjusting 60
Installation of Pinion
1. Install cup of rear pinion bearing
2. Install spacer and shims on pinion (basic thickness
1.5mm (0.059 in)).
3. Install bearing cone.
4. Tap bearing cone to correct position(Rotate pinion
3-5 times)
5. Assemble yoke and nut and tighten flange nut to
180 ±15 N·m (133±11 lb·ft)
6. Measure the rolling torque. The value of rolling
torque should be 1.5~2.0 N·m (1.1~1.5 lb·ft)
7. If the rolling torque exceeds 2 N·m, add one shim
and if it is lower than 1.5 N·m, subtract one shim
8. When the adjustment is correct, disassemble the
nut and the yoke. Assemble the oil seal and yoke
again and then tighten the nut to 180 ±15 N·m
(133±11 lb·ft)