Specifications

Vehicle System Disassembly & Assembly 87
Removal of Transmission
Start by :
a. Remove the mast.
Refer to the topic of " Mast " in this module for the
further information.
b. Remove the drive tire.
c. Drain the transmission oil.
d. Disassemble Drive axle.
1. Disconnect two hoses assembled to the hydraulic
pump.
2. Disconnect the inching cable.
3. Dismount the accel pedal.
4. Disconnect the parking cable.
5. Dismount the front plate.
6. Disconnect all harnesses, connectors and hoses.
7. After removing the trans. housing cover,
disassemble the torque converter plate from the
flywheel. For the purpose of reassembly, the torque
is 45 +/- 7 N.m (34 +/- 5 lb.ft).
8. Suspend the transmission and engine by hoist,
separately.
9. Reassembly in the reverse order of disassembly.
For the purpose of reassembly, the torque of bolts
for mounting the transmission is...............................
...............................240 +/- 40 N.m (180 +/- 30 lb.ft).
10. Adjust the powertain assembly after inserting Ø4
mm pin into the hole of trqnsmission housing