Specifications

Vehicle System Disassembly & Assembly 84

Universal Joint

Remove and Install Universal Joint

1. Remove four bolts (1).

2. Remove four bolts and nuts (2) and flange

assembly (3).

3. Remove yoke shaft assembly (4).

Use the following steps to assemble the universal

joint.

4. Install the yoke shaft assembly (4) into transmission.

5. Put the flange assembly in the position between the

drive axle and the yoke shaft assembly (4).

6. Apply loctite #242 thread lock to threads of the bolts

(1) and the bolts (2).

7. Tighten the bolts (1) and the bolts (2) to a torque of

75 ± 5 N·m (55.4 ± 3.7 lb·ft).

Counterweight

Remove & Install Counterweight

Tools Needed A

Link Bracket 4

NOTE : Steps 1 through 3 are for L.P. and Gas model

machines only. After steps 1 through 4 have been

done, the removal procedure is the same for all

models. For gasoline model machines, go to step 5.

1. Remove the L.P. fuel tank. Refer to the Operation &

Maintenance manual for further information.

2. Disconnect fuel line (1) from the LP converter.

3. Remove the washers and bolts (2) from each side

of L.P. tank mounting bracket (3). Remove mounting

bracket (3).

IDCD090P

IDCD092P