Specifications

Vehicle System Disassembly & Assembly 81

NOTE : Use bolts (2) and cap (3) to align steer axle

(4) with the mounting bosses while raising steer axle

(4) into position with the floor jack.

9. Seat steer axle (4) as follows:

a. Install bolts (2) through cap (3) and into the

mounting bosses approximately two bolt

threads.

b. Use the floor jack to raise steer axle (4) into the

mounting boss.

c. Tighten bolts (2).

10. Connect tube (1).

Steering Cylinder

Remove & Install Steering Cylinder

Start By:

a. Remove steer axle.

1. Remove the pin retaining bolt and pin (2) from the

tie rod at each end of steering cylinder (1).

2. Remove four bolts (3). For installation purposes, the

torque for bolts (3) is 300 ± 40 N·m (220 ±30 lb·ft).

3. Remove steering cylinder (1).

4. Install steering cylinder (1) in the reverse order of

removal.