Specifications

Vehicle System Disassembly & Assembly 70

Master cylinder

Remove & Install Master cylinder

NOTE : Plug and cap all openings to avoid

contamination and debris from entering the system

after removing any tubes or lines.

1. Before disconnecting the lines to master cylinder(1),

prepare the proper plugs.

2. Disconnect the hoses and the tubes assembled to

master cylinder, one by one.

Be sure that the oil in reservoir will be brained once

the hose (2) is disconnected.

NOTE : Put the proper marking on the hoses not to be

confused. Also, after being disconnected, put the

proper plug or plugging on the hoses and tube.

3. Disconnect the yoke (3) from bell crank.

4. Dismount the master cylinder.

5. Install the waster cylinder in the reverse order of

removal.

6. Fill the oil reservoir with the correct oil

recommended at Operating & Maintenance manual.

7. Bleed the brake system. Refer to the Testing and

Adjusting Manual for the further information.