Specifications

Vehicle System Disassembly & Assembly 68
21. Rotate spool and sleeve assembly until pin is
parallel with port face. Install drive, make sure you
engage drive with pin. To assure proper alignment,
mark drive as shown. Note relationship between
slotted end of drive to splined end of drive when
marking.
22. Install 73.5 mm [2.89 in.] ID seal in spacer plate or
gerotor (meter).
23. With seal side of meter toward spacer plate, align
star valleys on drive. Note the parallel relationship
of reference lines A, B, C, and D. Align bolt holes
without disengaging meter from drive.
IDCD298S
Drive
Port Face
Pin
Pin Parallel
with Port
Face
IDCD299S
Seal
IDCD300S
Drive
(Marked)
Star Valley
Pin
Port Face
Seal Groove this Side of Gerotor (Mete
r
)
A
B
C
D