Specifications

Vehicle System Disassembly & Assembly 67
16. Install seal gland bushing over the spool end with
a twisting motion. Tap the bushing in place with a
rubber hammer. Make sure the bushing is flush
against the bearing race.
17. Install retaining ring in housing. After installing ring,
tap on ring end or pry with screwdriver around
entire circumference of ring to properly seat ring in
groove.
18. Clamp housing in vise. Clamp lightly on edges of
mounting area. Do not over tighten jaws.
NOTE: Check to insure that the spool and sleeve are
flush or slightly below the 14 hole surface of the
housing.
ATTENTION: Clean the upper surface of the housing
by wiping with the palm of clean hand. Clean each of
the flat surfaces of the meter section parts in a similar
way when ready for reassembly. Do not use cloth of
paper to clean surfaces.
19. Install 73.5 mm [2.89 in.] ID seal in housing.
20. Install spacer plate. Align bolt holes in spacer plate
with tapped holes in housing.
IDCD294S
Retaining
Ring
Seal
Gland
Bushing
(with seals)
IDCD295S
Quad Ring
Screwdriver
Seal
Seal Gland
Bushing
Retainin
g
Ring
Dust Seal
IDCD296S
IDCD293S