Specifications

Vehicle System Disassembly & Assembly 66

11. Position the spool and sleeve assembly so that the

splined end of the spool enters the 14 hole end of

housing first.

ATTENTION: Be extremely careful that the parts do

not tilt out of position while inserting. Push parts gently

into place with slight rotating action, keep pin nearly

horizontal. Bring the spool assembly entirely within the

housing bore until the parts are flush at the meter end

or 14 hole end of housing.

Do not pull the spool assembly beyond this point to

prevent the cross pin from dropping into the discharge

groove of the housing. With the spool assembly in this

flush position, check for free rotation within the

housing by turning with light finger tip force at the

splined end.

12. Place housing on clean lint free cloth. Install 47.5

mm [1.86 in.] ID seal in housing.

13. Install 2 bearing races and the needle thrust

bearing in the order shown.

14. Install 25 mm [1 in.] ID dust seal in seal gland

bushing, flat or smooth side must face down

towards bushing.

15. Install the quad ring seal in seal gland bushing.

Smooth seal in place with your finger. Do not use

any seal that falls freely into pocket of bushing.

IDCD292S

IDCD293S

Bearing

Race(2)

Needle

Thrust

Bearing

Seal