Specifications

Vehicle System Disassembly & Assembly 58
6. Press in the shaft seal to bottom of the shaft seal
bore.
7. Assemble the snap ring.
8. Check the section seal. Use of a new one is
recommended in each case.
9. Clean all assembly faces again.
10. Put a rope of Loctite sealant out side the interlock
track on the body (it's for corrosion protection)
11. Fit an assembly fixture for shaft sea protection to
the drive shaft.
12. The assembly fixture should be oiled with clean
hydraulic fluid to lubricate the shaft seal lip during
assembly.