Specifications

Vehicle System Disassembly & Assembly 52

9. Remove seal (11) from the spacer.

10. Remove O-ring seal (12) and back-up ring (13)

from the head.

11. Remove seals (14), (15), and (16) from the head.

NOTE: Use the following steps to assemble the tilt

cylinder.

12. Install seal (14) in the head. Position the lip of the

seal toward the inside of the head.

13. Install seal (15).

14. Install seal (16) in the cylinder head. Position the

lip of seal (16) toward the outside of the cylinder

head.

NOTE: The curved side of back up ring (13) should

contact O-ring seal (12).

15. Install O-ring seal (12) and back-up ring (13).

Make sure the curved side of back-up ring (13) is in

contact with O-ring seal (12).

IDCD425P

IDCD426P

IDCD425P

IDCD426P

IDCD253P