Specifications

Vehicle System Disassembly & Assembly 50

6. Install cylinder rod (9) in the cylinder body.

7. Install rod cover (10) on the cylinder body. Use tool

(A) to tighten bearing.

8. Install flow protector valve (11) on the cylinder body.

End By:

a. Install primary lift cylinder.

Tilt Cylinder

Remove & Install Tilt Cylinders

NOTE: The procedure for removing and installing the

tilt cylinders is the same for both cylinders.

WARNING

If both tilt cylinders are removed at the same time

the mast can fall. To avoid possible personal

injury, make sure the mast is securely held in

place or supported by a hoist before removing the

tilt cylinders.

WARNING

To prevent personal injury, move the control

levers backward and forward to release any

pressure in hydraulic system. Slowly loosen the

cap of the hydraulic tank to release any pressure

in the tank. Be cautious of hot hydraulic oil when

any lines are disconnected in the hydraulic system.

1. Disconnect the connector (1). Remove retainer bolt

(2) and pin (3).

2. Remove retainer bolt (6) from pin (5). Remove pin

(6).

3. Remove tilt cylinder (4).

4. Install the tilt cylinder in the reverse order of

removal.

IDCD215P

IDCD210P