Specifications

Vehicle System Disassembly & Assembly 20

WARNING

Loosen the tension of straps to be connected with

hoist when mast assembly (2) is tilted forward.

If straps are too tight, mast assembly (2) could

slide off when bolts (8) are removed.

7. Use the hoist to remove mast assembly (2) from the

machine.

8. Install the mast in the reverse order of removal.

End By:

a. Install forks.

b. Fill hydraulic oil to tank*.

* Refer to the Operation And Maintenance Manual for

further information.

Disassemble Mast for FFT

NOTE : The standard, Full Free Lift and Full Free

Triple Lift mast are almost the same way. The mast

shown in the following illustrations is the Full Free

Triple Lift mast.

Start By:

a. Remove primary lift cylinder.

b. Remove mast.

NOTE: The following disassembly and assembly

procedure is for a full free triple lift mast.

1. Remove hoses (1) along with the hose support

clamps.

2. Remove hose sheave (3).

3. Remove chain nut (4) from the top of the mast

(each side).

IDCD021P

IDCD023P