Specifications

Vehicle System Disassembly & Assembly 18
5. Tighten screw (5) that holds the top bearings to the
carriage to a torque of 34 ±7 N·m (25 ±5 lb·ft)
6. In case of Quad mast shim stop bolt (11) as
required to obtain a 6 to 9 mm (.24 to .35 in) lap with
top carriage stop on the inner upright.
7. Position chains (6) on the carriage. Install pins
(7) and the roll pins.
End By:
a. Install carriage, raise the inner mast and insert the
carriage from the bottom of inner mast.
IDCD011P
IDCD009
11
6
7
8
9