Specifications

Vehicle System Disassembly & Assembly 15

To prevent personal injury be sure pressure in the

hydraulic system has been released before

disconnecting any hydraulic lines. Slowly loosen

the cap of the hydraulic tank to release any

pressure in the tank. Be cautious of hot hydraulic

oil when any lines are disconnected in the

hydraulic system.

NOTE: For purposes of reassembly, identify and mark

all hydraulic lines and connectors before removing or

disconnecting.

4. Remove four bolts (8) from the chain guard/hose

support assembly (6). Set the hoses aside, clear of

the primary cylinder and cross head.

5. Set the hoses aside. Remove two nuts (9) from the

chain anchors. And remove nuts (9-1) of clamp

together. Set the chains aside, clear of the mast.

6. Raise the inner mast to pull out carriage as shown.

7. Remove carriage from bottom of inner mast (15).

Carriage (14) weighs 116kg (255 lb).

NOTE: Use the following steps to install the carriage.

8. Raise the inner mast to put in the carriage onto the

mast, and lower the inner mast to cover carriage

bearing fully.

9. Put the chains in position over cross head (12).

Install nuts (9) onto the chain anchors to a torque of

800 ± 100 N·m (600 ± 75 lb·ft).

WARNING

IDCD010P