Specifications

Vehicle System Disassembly & Assembly 12

Carriage

Remove & Install Carriage for STD,

FFL & FFT

Tools Needed A

Retaining Ring Pliers 1

Start By:

a. Remove forks.

b. Remove backrest.

1. Raise carriage (1). Position a wooden block as

shown. Lower carriage (1) onto the wooden block.

2. Disconnect two hydraulic lines (4) from side shifter

cylinder (2). Plug and cap all openings to prevent

contamination and debris from entering system.

To prevent personal injury be sure pressure in the

hydraulic system has been released before

disconnecting any hydraulic lines. Slowly loosen

the cap of the hydraulic tank to release any

pressure in the tank. Be cautious of hot hydraulic

oil when any lines are disconnected in the

hydraulic system.

NOTE: For purposes of reassembly, identify and mark

all hydraulic lines and connectors before removing or

disconnecting.

3. Remove four bolts (5) from the chain guard/hose

support assembly (6). Set the hoses aside, clear

from the primary cylinder and cross head.

IDCD004P

WARNING