Specifications

Operation Section
-117-
Table 2. Diagnostic Fault Codes (Flash Codes) cont’d.
DFC PROBABLE FAULT FAULT ACTION *
CORRECTIVE ACTION FIRST
CHECK
612
(65)
APP2RangeLow
APP2 sensor voltage out of range
low, normally set if the APP2 signal
has shorted to ground, circuit has
o
p
ened or sensor has failed
TurnOnMil
Check foot pedal connector
• Check APP2 signal at SECM PIN
B16
621
(62)
APP1RangeHigh
APP1 sensor voltage out of range
high, normally set if the APP1 signal
has shorted to power or the ground
for the sensor has opened
TurnOnMil
Check foot pedal connector
• Check APP1 signal at SECM PIN
B7
622
(66)
APP2RangeHigh
APP2 sensor voltage out of range
high, normally set if the APP2 signal
has shorted to power or the ground
for the sensor has o
p
ened
TurnOnMil
Check foot pedal connector
• Check APP2 signal at SECM PIN
B16
631
(63)
APP1AdaptLoMin
Learned idle end of APP1 sensor
range lower than expected
TurnOnMil
Check APP connector and pins for
corrosion
• Cycle the pedal several times and
check APP1 signal at SECM Pin
B7
632
(67)
APP2AdaptLoMin
Learned idle end of APP2 sensor
range lower than expected
TurnOnMil
Check APP connector and pins for
corrosion
• Cycle the pedal several times and
check APP2 signal at SECM Pin
B16
641
(64)
APP1AdaptHiMax
Learned full pedal end of APP1
sensor range higher than expected
TurnOnMil
Check APP connector and pins for
corrosion
Cycle the pedal several times and
check APP1 si
g
nal at SECM Pin B7
642
(68)
APP2AdaptHiMax
Learned full pedal end of APP2
sensor range higher than expected
TurnOnMil
Check APP connector and pins for
corrosion
Cycle the pedal several times and
check APP2 si
g
nal at SECM Pin B16
651
APP1AdaptHiMin
Learned full pedal end of APP1
sensor range lower than expected
TurnOnMil
Check APP connector and pins for
corrosion
Cycle the pedal several times and
check APP1 si
g
nal at SECM Pin B7
652
APP2AdaptHiMin
Learned full pedal end of APP2
sensor range lower than expected
TurnOnMil
Check APP connector and pins for
corrosion
Cycle the pedal several times and
check APP2 si
g
nal at SECM Pin B16
661
APP1AdaptLoMax
Learned idle end of APP1 sensor
range higher than expected
TurnOnMil
Check APP connector and pins for
corrosion
Cycle the pedal several times and
check APP1 si
g
nal at SECM Pin B7
662
APP2AdaptLoMax
Learned idle end of APP2 sensor
range higher than expected
TurnOnMil
Check APP connector and pins for
corrosion
Cycle the pedal several times and
check APP2 si
g
nal at SECM Pin B16
691
(69)
APP_Sensors_Conflict
APP position sensors do no not track
well, intermittent connections to APP
or defective pedal assembly
(1) TurnOnMil
(2) Cut Throttle
Check APP connector and pins for
corrosion
• Cycle the pedal several times and
check APP1 signal at SECM Pin
B7
• Cycle the pedal several times and
check APP2 signal at SECM Pin
B16
(*) Fault actions shown are default values specified by the OEM.