Service manual

G420F(FE) Service Manual 317 Appendix
STEP 4 - PROGRAM THE MODULE
Once the desired upgrade is located and highlighted,
select Next to upgrade ithe module.
Follow the on-screen instructions to complete the
update process. Once the programming process
begins, it must run to completion. If power is
interrupted or the process fails, the SECM may be
rendered unusable. Several update screens will
provide a running status of the upgrade process, as
shown below.
Once the upgrade process is complete, a “complete”
message will appear and will give the operator the
option of upgrading another module. If another
module is to be upgraded, select the “Upgrade
again” button and select next. If another upgrade is
not required, select finish.
Note 1: After successfully upgrading the SECM,
MotoViewer software will not function without the
appropriate translation file (.dll) discussed in Step-1
above.
Note 2: If the programming is unsuccessful, the
programming process may be repeated. If
repeatedly unsuccessful, please contact .
Highlight the upgrade option desired,
then select Next