Service manual

G420F(FE) Service Manual Chapter 4. Engine Electrical System
149
9. Bruch Replacement
1) Remove the worn brush taking care not to
damage the pigtail.
2) For better welding, correct the pigtail end with a
sand paper.
3) Weld the pigtail end.
10. Installation of Rear Bracker.
1) Before removing the bushing, measure the
bushing press-fit depth.
2) Remove the bushing as shown in the
illustration.
3) Press-fit a new bushing as the depth measured
procedure 1).
Assembly
1. Install the overrunning clutch to the armature
shaft front end.
2. Install the stop ring and snap ring to the armature
shaft front end and completely press the stop ring
toward the snap ring.
3. When installing the lever to the front bracket, take
care of the direction. If the installation direction is
in reverse, the pinion will move outward only.