Service manual

G420F(FE) Service Manual Chapter 3. Engine Mechanical System
116
14. Install oil screen.
Install a new gasket (B) and oil screen (A) with 2
bolts (C).
Tightening torque
12~15Nm (120~150kgf.cm,9~11lbf.ft)
15. Install oil pan.
1) Using a razor blade and gasket
scraper, remove all the old packing material from
the gasket surfaces.
NOTE: Check that the mating surfaces are clean
and dry before applying liquid gasket.
2) Apply liquid gasket as an even bead,
centered between the edges of the mating surface.
Use liquid gasket MS721-40A or equivalent.
NOTE: To prevent leakage of oil, apply liquid gasket
to the inner threads of the bolt holes. Do not install
the parts if five minutes or more have elapsed since
applying the liquid gasket. Instead, reapply liquid
gasket after removing the residue. After assembly,
wait at least 30 minutes before filling the engine with
oil.
3) Install the oil pan (A) with the 19 bolts.
Uniformly tighten the bolts in several passes.
Tightening torque
10~12Nm (100~120kgf.cm, 7.3~8.8lbf.ft)
16. Install water pump. (see page EM-104)
17. Install oil pressure sensor.
1) Apply adhesive to 2 or 3 threads.
Adhesive: MS721-39 (B) or equivalent.
2) Install the oil pressure sensor (A).
Tightening torque
15~22Nm (150~220kgf.cm, 11~16lbf.ft)