Technical information

TESTING LOOP DETECTION SYSTEMS TESTING LOOP DETECTION SYSTEMS
ACCESS CONTROL SOLUTIONS . . . 19 Preventative Maintenance Guide
Detector Adjustments: Detector Adjustments:
Frequency: Separate each loop to avoid CrossTalk Frequency: Separate each loop to avoid CrossTalk
Sensitivity: How much change is needed in Loop
Field to detect. Can affect height of detection.
Sensitivity: How much change is needed in Loop
Field to detect. Can affect height of detection.
Boost: automatically boosts to an extermely high
sensitivity upon detection When vehicle leaves loop,
sensitivity drops back to original setting.
Boost: automatically boosts to an extermely high
sensitivity upon detection When vehicle leaves loop,
sensitivity drops back to original setting.
Fast Trak: USE WITH CAUTION! This will help
detector adjust as loop tuning drifts. This also will lower
Hold Time if a car parks over the loop
Fast Trak: USE WITH CAUTION! This will help
detector adjust as loop tuning drifts. This also will lower
Hold Time if a car parks over the loop
LED: Red for Detect. Flash count on start-up to
show frequency. Continuous blink indicates Loop
Fault occurred. Will continue till reset.
LED: Red for Detect. Flash count on start-up to
show frequency. Continuous blink indicates Loop
Fault occurred. Will continue till reset.
Detect LED
Solid Red - indicates vehicle presence, or that
detector is "Locked ON"
Flashing Red - Indicates that a failure occured in
Loop Circuit. If detector has automatically reset, this
will continue to flash showing that a fault had occured.
Reset
Button
Sw 2
Sw 3
Sw 4 = Sens
Boost
Sensitivity
Frequency
Switches
Power LED
Detect LED
1
2
Frequency
High 1 OFF, 2 OFF
Med-Hi 1 OFF, 2 ON
Med-Lo 1 ON, 2 OFF
Low 1 ON, 2 ON
1
2
3
4
Operation Settings
Fast Trak 1 OFF=Normal
1 ON = Fast Trak
Sensitivity
Low 2 OFF, 3 OFF
Med-Lo 2 OFF, 3 ON
Med-Hi 2 ON, 3 OFF
High 2 ON, 3 ON
Sensivity 4 OFF= Normal
Boost 4 ON = Boost
Reset Button
Press to reset Detector, or
when changing Frequencies
&/or Sensitivity