Instructions / Assembly

Main engine

Magnetic limit switch block

Magnet

Chain

Chain wheel

Gate

≤20mm

Note:

The default setting is right side mounting.

(Please refer to “Adjustment and operation” in 4.3.5 for adjustment instructions.)

Figure 13 Figure 14

Gate

Magnet

Chain

Magnetic limit

switch block

Nut M8

Spring washerφ8

Flat washerφ8

Control Board

Connections and Indicators Diagram

Figure 15

Open/Close: Light indicators for gate movement direction. When OPEN is on, the gate should be opening. When CLOSE is on, the gate should

be closing. If CLOSE is on while the gate is opening, change the direction of the SW1 switch from REV to FWD.

IR: The IR indicator light will continually be on until the IR sensor’s path is obstructed.

CLLM: The CLLM light will be on when the gate’s closing limit is reached.

OPLM: The OPLM light will be on when the gate’s opening limit is reached.

OSC: The OSC light is an indicator light for the circuit board’s functioning. Press TEST to test the circuit board’s operational state. If the OSC

indicator light does not shine when pressing TEST, the circuit board is non-functional.

Connection Interface Terminals

Power X4:PE, N, L

Caution/Alarm Lamps X2:D1, D2

External Button X5: COM, OSC

Photocell Infrared Sensor X6: 24VDC, GND, I.R