Installation Guide

ManualsBrandsDoor Canopy in a Box ManualsAwnings4 ft. Traditional Non-Retractable Door Canopy (50 in. Projection) in Ebony

Basic Tools Required

Tape Measure &

Pencil Level

Phillips Screwdriver

Drill with ¼” bit

Ladder

Note: Make sure that the Door Canopy you purchased exceeds

the door width.

General Comments



Wash your hands before installation and be sure they are clean when

handling the fabric.



Always be careful with the fabric during installation.

Drills, screwdrivers and other items can puncture the fabric.



This and other customer installation damage is not covered by the warranty.



A second person to assist in holding the door canopy up when installing your

canopy is RECOMMENDED.

Included in canopy kit

Item

Part

Number

Description

Canopy Traditional & Classic Designs

4ft

6ft

8ft

1200145

Head Rod Clamps

1200144

Hinge w/bolt attached

1200148

Eye End

1200093

Screws #10 (1 ½”)

1200147

Elbow

1200720

Internal Connectors

1410012

Canopy instructions Sheet

N/A

Canopy Fabric Cover

1300222

Head Rod Bar

(Inside Threaded Pipe with Black

Cap on end)

Installation Instructions

Traditional Canopy in a box™

Classic canopy in a Box™

Canopy

instruction

Summary of content (5 pages)

PAGE 1
Installation Instructions Traditional Canopy in a box™ Classic canopy in a Box™ Basic Tools Required Tape Measure & Pencil Level Phillips Screwdriver Drill with ¼” bit Ladder Note: Make sure that the Door Canopy you purchased exceeds the door width. General Comments     Wash your hands before installation and be sure they are clean when handling the fabric. Always be careful with the fabric during installation. Drills, screwdrivers and other items can puncture the fabric.
PAGE 2
Side Arms J 1300225 K Front Bar 1300225 (Inside/outside Threaded Pipe) L 1300223 (Inside / Outside Threaded Pipe) Center Center Bar Bar (Inside Threaded Pipe Both Ends) ASSEMBLY 4 4 4 2 2 2 0 0 22 4 4 DRAWING This Set Applies Only For 6’ & 8’ Awning. 6 Ft Awning= Use 1 Set 8 Ft Awning= Use 2 Sets D D L B C A FF I C I I D D C D D J D D D D DD A F A B F J J D J D FC F J J J F J J D D This Set Applies Only For 6’ & 8’ Awning.
PAGE 3
Traditional & Classic Door Canopy Assembly and Mounting 1. Installing the head rod clamps, spacing evenly starting 6" from each end of the door a) Drill pilot or anchor holes for each head rod clamp. b) Fasten both head rod clamps to the wall, use a level to ensure clamps will be level with each other and centered above door or opening. 6.0" 6.0" A A D D D D D Door 1. Assemble the Head Rod bar using the internal connector. I F I a) Slide the Head Rod bar into the head rod pocket (see below).
PAGE 4
6. Straighten the front bar; making sure the door canopy is level and straight. 7. Screw both camelback hinges into the wall. 8. Remove middle screw on the hinge and attach the Arms (eye end attached to the hinge). Tighten screw in slot. f I I J f J J f J f K K Product Care and Maintenance We use only quality fabrics in the manufacturing of our products, but fabrics do have a few limitations; therefore proper care of your canopy is important to extend its life.
PAGE 5
Customer satisfaction and end user satisfaction is a number one concern and priority.