Installation Guide
1.
Find the upper Hinge Shield support
, (5) 2-1/2 inch and (7) 3-1/2 inch
screws.
2.
Remove the screws attaching the
upper hinge to the door. Save these
screws as they will be needed to
reattach the hinge to the door.
3
. With the door hinge plate free,
maneuver the support between the
door and the jamb so that the
unsecured hinge plate goes through
the opening in the support.
4.
Position the upper Hinge Shield on
the doorjamb. One of the long tabs at
the end of the piece should extend
upward and the rounded cutout, with
the screw hole in its center, (fig. 1) is
located at the top of the door jamb and
interfacing with the edge of the door
slab.
U
pp
e
r
Hi
ng
e
S
h
i
e
l
d
Rounded
cutout with
screw hole
(fig.1)
Mark
here
D
I
H
G
H
C
e
n
t
e
r
L
o
c
k
s
i
d
e
S
h
i
e
l
d
1.
Locate the Center Jamb Shield
support piece with multiple cutouts
along one side, (3) 2-1/2 inch and
(6) 3-1/2 inch screws.
2.
Position the piece along the center
section of the lock side door jamb
ensuring the lock bolt holes of the door
jamb are aligned with the appropriate
cutouts on the piece. With the
component flush against the interior
edge of the door jamb, predrill with
9/64th-inch drill bit and install the
central side screw, from the door side,
with the supplied 2-1/2 inch screw
.
Repeat for top and bottom screw
holes.
B
e
s
u
r
e
t
o
u
s
e
a
s
c
r
e
w
t
h
a
t
w
ill
no
t
c
o
m
e
i
n
t
o
c
on
t
ac
t
w
i
t
h
t
h
e
g
l
a
ss
o
f
t
h
e
s
i
d
e
li
gh
t
.
3.
Pre-drill the holes on the interior
11/64th-inch drill bit and secure the
Shield in place with the supplied 3-1/2
inch screws .
A
B
A
C
F
Sidelight
glass
A
H
G
4.
Clean all debris from the lock bolt holes and ensure
the lock operates freely and engages smoothly into the
holes of the Center Jamb Shield and door jamb.
G
H
The upper tab should extend
upward over the upper jamb
with the screw hole coming
to rest on the rough frame
above the door. The lower tab
should extend along and be
flush with the interior edge of
the door jamb.
D
D
H
H
G
G
G
H
G
H