Installation Guide

4. Re-install the support
piece. Ensure the circular
tab is positioned over the
previously drilled hole as
detailed in step 2.
5. While ensuring the piece
stays aligned, pre-drill the
holes on the interior trim
edge of the support with a
11/64th-inch drill bit and
install the supplied 3-1/2
inch screw . The hole
positioned over the rough
frame should be predrilled
and also receive a 3-1/2
inch screw.
6. Pre-drill the door side
screw holes with 9/64th-inch
drill bit and install the central
side 2-1/2 inch screw
into the support on the jamb,
as detailed.
B e s u r e t o u s e a s c r e w
t h a t w ill no t c o m e i n t o
c on t ac t w i t h t h e g l a ss o f
t h e s i d e li gh t .
The side screws should go
through both the support
piece, the door jamb and
extend into the adjacent
side light panel.
7. With a pin punch or other
appropriate blunt instrument
and hammer, tap the cutout
tab so that it bends into the
predrilled 1/2-inch hole.
(If there is difficulty due to
hole misalignment, enlarge
the hole slightly to
accommodate the bending
of the tab)
The upper tab should be
positioned so that when the
screw is installed, maximum
penetration into the upper
rough frame can be realized.
Sidelight
glass
Jamb
support
Sidelight
panel
Screw
guide tab
Rough
frame
Rough
frame
8. Pre-drill the hole in the
upper tab with 9/64th-inch drill
bit ensuring the drill bit goes
on an upward angle through
the vertical doorjamb, upper
horizontal jamb and as far as
possible into the upper rough
frame. Secure the upper tab
with the supplied 3-1/2 inch
screw .
H
9. Pre-drill remaining holes with
9/64th-inch or 11/64th-inch drill
bit and insert screws, using
3-1/2 inch or 2-1/2 inch screws
where appropriate.
A g a i n e n s u r e t h e d r illi ng
a nd t h e s c r e w s w ill no t
c on t ac t t h e g l a ss o f t h e
s i d e li gh t .
G
H
G
H