Installation Guide

J a m b S h i e l d I n s t a ll a t i on
U pp e r L o c k s i d e S h i e l d
Rough
frame
B
A
C
F
Sidelight
glass
1. Locate the Upper Jamb Shield
support , (2) 2-1/2 inch
and (6) 3-1/2 inch screws .
Position the Upper Jamb Shield
support on the door jamb with the
long tabs turned vertically. The
upper tab should extend upward
over the upper jamb with the
screw hole coming to rest on the
rough frame above the door.
The side with screw hole and
rounded cutouts (fi g . 1 ), should
be on the door side of the door
jamb and interface with the top
of the door jamb.
2. Hold the piece in position on
the jamb. Make sure the door
side edge of the piece slides
behind the weather stripping.
Once the support piece is
positioned properly, locate and
mark the center of the screw hole
of the upper rounded cutout
(fig.1) on the door jamb.
3. Remove upper Jamb Shield
and with a 1/2-inch drill bit, drill
a 1/2-inch hole approximately 1/2-
inch deep into the jamb at the
marked location.
B
Door
slab
G
H
Mark
screw
guide tab
Upper
shield
1/2 inch
bit
Drill at
screw
guide
tab mark
H
G
B
Rounded
cutout with
screw hole
(fig.1)
Mark
here
Mark
here
C
Rounded
cutout with
screw hole
(fig.1)
A
G
H
H
G
H
H
H
G