Installation Guide
D
oo
r
J
a
m
b
P
r
e
p
N
o
t
e
:
I
n
a
ll
s
t
e
p
s
i
t
i
s
i
m
p
e
r
a
t
i
v
e
t
o
e
n
s
u
r
e
t
h
a
t
a
t
no
t
i
m
e
a
n
y
d
r
illi
ng
o
r
s
c
r
e
w
p
l
ace
m
e
n
t
c
o
m
e
i
n
c
on
t
ac
t
w
i
t
h
t
h
e
g
l
a
ss
ca
s
e
m
e
n
t
o
f
t
h
e
s
i
d
e
li
gh
t
.
1.
Carefully score along trim edges with
sharp tool such as a razor knife.
2.
Gently pry and remove interior door
trim molding and all trim molding on the
sidelight panels that is immediately
adjacent to the door jamb exposing the
door jamb separating the door and
sidelights.
(This trim can and should be reinstalled
upon installation completion.)
Lock bolt and
latch assemblies
3.
With the Door Shields
in place, make sure the
Door Shields are level
and flush against the
door slab on all sides.
4.
Verify that the locks
can function properly
without interference
from the Door Shields.
If there is intereference,
adjust the Door Shields
until the locks operate
freely. If there is no
interference, the
installation is complete.
D
oo
r
S
h
i
e
l
d
I
n
s
t
a
ll
a
t
i
on
1.
Slide the Mini Door
Shield onto the door
position so the holes will
go over the lock bolts.
2.
Using the supplied
2-1/2” screws , secure
the Door Shield to the
door slab using the hole
above and below screw
lock bolt holes.
G
F
Lock bolt and
latch assemblies
F
G