+ DMK-25 midi keyboard «+ Standard USB cable + Owner's Manual TT MINES ee] EEE DIKE =z 1. PITCH/MODULATION 4 Assignable Touch Bar, can be assigned to send Control Change message (hereinafter called the ‘CC’) or Pitch Bend Change message (hereinafter called the Pitch’). 4 The MIDI Channel Is assignable for sate of them . The range Is 0~16. 0 Is the Global channel, which will follow the Keyboard's channel. 1~16 is the standard MIDI channel.
. TRANSPORT BUTTON KINDA Assignable Buttons, can be assigned to send CC messages. A The MIDI Channel is assignable for each of them. The range is 0~16 (the same as the Touch Bar). 4 The Buttons have 2 Modes, 0 for Toggle,1 for Momentary. = Toggle: The button “latches”; it sends its message continuously when it is first pressed and stops sending it when it is pressed a second time. = Momentary: The button sends its message while being pressed and stops sending it when it is released. 4.
Note: Every time the DMK25 is muted on, the settings in the RAM registers will be read. If you need to use the custom settings PROGRAMMING, you need to use the [LOAD] function to load them. Every time after editing DMK25, you need to use the [SAVE] function to save. 4 Program Presets, PROROGATION.
« if the Keyboard, the [OCTAVE blink. A Use the number key 0~2 to enter the number like this way: 000, 001, A Choose another unit you want to assign one by one before EXIT or ENTER. CHANNELIZE: A Assign each unit's channel. A Press [CN] to enter Channel Assignment state, choose one unit you want to assign, the same as above. 4 Press any blank key (the key without any function the Keyboard to choose the Keyboard.
The following table shows the default parameters for each module of the machine based on Standard MIDI, listing the range of settings available for each module CC and CN and their default values.
protocol. For example, changing the CC of a control unit, such as knob K1, to 7 will allow knob K1 to perform the pounding function of controlling the volume of its channel. Or changing the CC of a control unit, such as knob K1, to 11 will allow knob K1 to control the expression output, Other similarly. NO.
684 SUSTAIN PEDAL «63 OFF, >64 ON 65 TORMENTOR «83 OFF, >64 ON 66 OSTENTATION «83 OFF, >64 ON 67 SOFT PEDAL «63 OFF, >64 ON 68 LEGATO FOOT SWITCH <63 NORMAL, >54 LEGATO 69 HOLD 2 <63 OFF, >64 ON 70 VARIATION 0127 7 RESONANCE 0-127 72 RELEASE TIME 0127 73 ATTACK TIME 0127 74 CUTOFF 0-127 75 DECAY TIME 0-127 76 VIBRATO RATE 0-127 77 VIBRATO DEPTH 0-127 78 VIBRATO DELAY 0-127 79 UNDEFINED 0127 80 GENERAL PURPOSE CONTROLLER 5 0-127 81 GENERAL PURPOSE CONTROLLER & 0-127 B82 ‘GENERAL PURPOSE CONTROLLER 7 0-127 83
