User's Manual
Troubleshooting
Specifications
Check point
When a disc is brought from a cold environment to a hot one, there may be steam on the
face of the disc, or water will appear on the pickup lens. It will be affected disc play.
1. Remove the disc from the DVD player.
2. Turn on the power and leave it on for an hour to vaporize the condensation.
3. You can operate the DVD player without any problems.
Button does not work.
Is the power turned on? Check the car battery capacity.
No sound
Is the audio which is connected with
the audio cable set to receive
the DVD signal output?
Select the correct input mode for the audio receiver.
No picture
Is the monitor set to receive
the DVD signal output?
Select the proper video input mode in the monitor
and check to see if the DVD playback screen is
displayed on the monitor.
Is the video cable connected correctly? Connect the video cable correctly.
Is the monitor powered on? Turn the monitor power on.
No playback
Remote control does
not work properly.
Is the remote control facing
at the remote sensor?
Point the remote control to the remote sensor of the
product.
Is the distance too far? Use the remote control within 5m.
Is there any obstacle in the middle? Remove the obstacle.
Is the battery exhausted? Replace with new batteries.
Is the disc incompatible? Insert the compatible disc. (Check disc type, color
type and area code)
Is the disc put upside down? Insert a disc with the playback side down.
Is the disc contaminated with dust? Clean the disc.
Is the menu displayed on the monitor? Press the function selection button to close the
menu screen
Is the rating level correct? Cancel the parental function or change the parental
level.
Is audio cable is connected securely? Connect the audio cable into the jacks securely.
Is the monitor which is connected
with the audio cable turned on?
Turn on the monitor connected with the audio
cable.
Is the digital audio output set
in the correct position?
Set the Digital Audio Output to the correct position,
and then turn on the DVD player again by pressing
the POWER button.
Items to Check Actions to be TakenSymptom
Note : This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the
interference at his own expense.
1PXFS DC 12V
4DSFFO'PSNBU
3FTPMVUJPO
#SJHIUOFTT
$PMPS4ZTUFN
"7*OQVU
"70VUQVU
3FNPUF$POUSPM
%JNFOTJPO
16 : 9
800(RGB) X 480 Pixel
350 cd/
NTSC / PAL Auto Selection
2EA
1EA
4DSFFO4J[F 12" Wide
*35SBOTNJUUFS Yes
Yes
14.96"(W) x 14.96"(D) x 2.55"(H)