Instruction of Robot Vacuum Cleaner （Please read the instruction carefully before use and keep it well） Model：ZK901
Content Machine and accessories Product introduction Product installation Instruction Product maintenance Product parameters The name and content of hazardous substances in the product Voice prompts and trouble-shooting FAQ Safety information
Machine and accessories The following product and accessories will be found after opening the package, please check carefully.
Product introduction Keys on the machine Power key： *Short press: Sweep/pause *Long press: On/off the machine Color of power indication light: *White: Power ≥20% *Red: Power ≤20% *Breathing light flashing: Charging *Red quick flashing: Faulty WiFi indication light： *Slow flash: Waiting for connection *Normally on: WiFi is connected *Quick flash: WiFi connection failed Recharge key： *Short press: recharge / pause *Long press: Timing cleaning 02
Product introduction Front of machine Rear of machine Exhaust port Anti-dropping sensor Charging pole piece Laser radar Universal wheel Side brush Radar collision sensor Side brush Rolling brush Cover Rolling brush cover Driving wheel Mop component Alignment sensor Mop buckle Collision sensor Infrared sensor 03
Product introduction Machine Dust box Machine cover Dust box buckle Cleaning brush Filter bracket Reset key High efficiency filter Wall sensor 04 Primary filter
Product introduction Mop Water tank Sealing plug Water inlet for mop Water tank buckle Fixed buckle Charged pole piece Mop buckle Suction port component Suction port Buckle *The components on this page are optional and that can be configured based on different demand of customers.
Product installation 03.Charge the robot vacuum cleaner on the charging stand 01. Charging stand Take the charging stand out from the package. *During the charging of the robot vacuum cleaner on the charging stand, it will automatically turn on. Signal indication light Power interface Color of power indication light *White: Power ≥20% *Red: Power ≤20% *Breathing light flashing: Charging *Red quick flashing: Faulty Charging terminal 02.
Instruction On/Off 3. If the machine is turned off automatically due to low power, you can manually take it back to the charging stand for charging. Make sure the charging electrode is in good contact and check whether the charging indication light is on. 4.After the machine is fully charged, please turn it off if it doesn’ t work. If the charging is kept for a long time, which may damage the battery. 1. In case the main machine is being charged on the charging stand, it will automatically turn on. 2.
Instruction Precautions before use *Please clean up small objects, fragile articles, cables, curtain ropes, etc. scattered on the ground before use to prevent entanglement or damage of the property. * The users with a duplex structure such as stairs etc. in their homes shall specially note that it is strictly forbidden to use the product in the fenceless suspending environment, which is higher than that of the family activities.
Product maintenance Cleaning of the dust box and filter 4. Clean the dust box and filter with a cleaning brush. The dust box and primary filter can be cleaned with water。 1. Open the machine cover upwards and remove the dust box. 5.Please thoroughly dry the dust box and filter after washing with water. Install the dust box in the machine after installation of the filter. 2.Open the dust box cover and remove the garbage inside. 3.
