Installation Instructions

01 02 03
04 05 06 07 08 09
10 11 12
13 14 15
16 17 18 19
Product maintenance
Sensor Switching of the suction port component and
rolling brush component
Firmware upgrade
The sensors include the following:
1.Lidar
2. Infrared sensor
3.Anti-dropping sensor
4.Wall sensor
5.Radar collision sensor
6.Alignment sensor
Roller cover
Suction
component
Buckle
Rolling brush
Rolling groove
Lidar
Radar collision sensor
Alignment sensor
Collision sensor
Infrared sensor
Wipe the various sensors on the main machine with a soft
and dry cloth to keep the sensor surface free of dirt and
dust.
1. The default configuration of the machine is the rolling
brush component, and the suction port component is the
optional accessory.
2. Switching method:
* Turn the machine, and press the buckle on the rolling
brush cover to remove the rolling brush component.
* Align the buckle of the suction port component with that on
the machine to install.
You can check and upgrade the device firmware through the
device settings page on APP. During updating, please make
sure that the machine is charging and the power is not less
than 60%. And please refer to the instruction in the APP for
the update procedure.