User's Manual

Select MASS ACTIVESYNC and tap to save the setting.

2. Install the application Mobile Device in a drive of PC. Then the following icon will

appear in the drive selection.

3. Connect the MINI USB terminal of the USB cable to the MINI USB port of the GPS

navigator and the standard USB terminal to the USB Host port of PC.

4. After the PC finds new hardware, double click the Mobile Device drive in the selection

area to enter the memory of GPS navigator for data transmission.

5. After transmission, unplug the USB cable.

[Attention] For data safety back up the navigator data. We assume no responsibility for

data loss or damage

[Note] If MASS STORAGE is selected while the GPS navigator is connected with PC,

other operations will be suspended.

[Attention] The following operations will stop suspend the communication of the system

and PC and unsaved data will be lost.

1. Unplugging the MINI USB cable;

2. Powering off the GPS navigator;

3. Resetting the system;

4. Tap the on close button on the top right.

8.10 Navigation Path

Insert a T-flash card with map data into the GPS navigator and tap to enter the