User's Manual

39
8.9.1 MASS STORAGE
1. Have the GPS navigator in operation status and the SD card plugged in the slot;
2. Tap
in the system setting interface to enter USB Option as shown below.
Select MASS STORAGE and tap to save it.
3. Connect the MINI USB terminal of the USB cord to the MINI USB port of the GPS
navigator and the standard USB terminal to the USB Host port of PC. Then the PC will
recognize the navigator and prompt the following interface. To disconnect the navigator
from PC and enter USB charging mode, you may select
.
2
4. After communication, unplug the MINI USB cable.
8.9.2 MS ACTIVESYNC
1.
Tap in the system interface to enter USB Option as shown below.