Installation Instructions

5V USB
Adapter
Micro USB
Cable
Red
Black
Wall
Console
LED
Button
Garage Door
Opener
Wall
Garege door
Wall
Garege door
thisif thenthat
(Moved with the door)
S ensor without cable
S ensor with cable
S ensor cable
S ensor cable
Wall
Garage door
Wall mounted door control
Wires
Eachen
Smart Garage
Door Switch
EASY INSTALLATION
Smart Garage
Door Switch
Smart Garage
Door Switch
1. Power up the Smart Garage Door Switch, the Red LED is off.
Smart Garage
Door Switch
Insert the 2.0mm terminal of the sensor to the smart garage door switch, then
steady install the sensor and the magnet of the gap within 3mm to 15mm on
your garage door with screws/bracket/3M gums/wall nail/line holders/ties.
Insert the Red & Black wire 2.0mm terminal to the smart garage door switch, then
put each end to the same terminals as the wall button wires are terminated to.
One Smart garage
door switch can only
control one garage door.
But the APP can add
mutiple Smart garage
door switch.
Tap to enter full function
operation interface.
Smart Garage Door Switch
Power up the Smart Garage Door Switch with your USB adapter, the Red LED is off.
Smart Garage
2. Use the included Red & Black wire connect the Smart Garage Door Switch to your
opener: Put each end to the same terminals as the wall button wires are terminated to.
3. Use a tiny screw or nail to click the button in the Smart Garage Door Switch, your
garage door should activate.
NOTE: Please have 5-second long press for network pairing
Door Switch for 5s, until the RED LED rapidly blinks (twice per second).